Builder Flips Jeep Rear Differential to Create a Budget Portal Axle

Zeph Gage pairs a Ford 9-inch housing with Humvee geared hubs and Jesse Haines Fabrication adapters to add rear clearance at a fraction of a commercial portal set's cost.

Portal axles are prized by hardcore four-wheelers for the clearance they add, but a set from specialists such as 74Weld typically runs about $20,000. Zeph Gage's take on the idea costs roughly a fifth of that, and he is running it only on the rear of his Jeep. The centerpiece is a Ford 9-inch axle housing whose differential has simply been flipped upside down.

What portal axles do

Portal axles place a stack of gears behind each driven wheel instead of hanging shafts and driveline parts below the transmission and transfer case. That lets the axle shafts sit high, leaving very little hardware below the frame line. Fitted with tall tires — the 37-inch BFGoodrich KM3 mud terrains used in one Arctic test — the arrangement can open up enough room for a picnic under the vehicle while it is parked, as Andrew Collins wrote in his account of driving portal-axle Ineos Grenadiers in the Arctic.

Turning low-pinion parts upside down

Gage's version combines a Ford 9-inch housing, geared hubs sourced from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters. Two-gear portals of the Humvee type reverse the rotation of the input shaft, which would ordinarily send the driveline spinning the wrong way. Flipping the differential upside down corrects the direction of rotation, and a Yukon Gear and Axle third member is then bolted to the diff. In effect, the build turns low-pinion parts into a budget high-pinion unit by inverting them.

The conversion is said to do more than add roughly six inches of clearance. It also keeps full shock travel, which is difficult to preserve with portal axles, and reduces stress on the differential itself, which should make the setup effectively bulletproof.

Why only the rear

Fitting a portal only at the rear, rather than upgrading both ends, follows a common trick in the remote-control rock crawler scene. Keeping the solid axle up front frees Gage from the packaging constraints that usually appear when portal axles are fitted to a vehicle that never had them from the factory. It also means he does not have to limit shock travel to make them fit, and the ride height does not climb absurdly high. The result is described as a best-of-both-worlds arrangement.

Custom fabrication, not a kit

This is not an off-the-shelf solution. The build required substantial custom work, from homemade brackets and custom-tapped plates to a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly for its integrated electric emergency brake solenoid and partly, again, for clearance.

The finished XJ Jeep can drive over a five-gallon bucket and still leave several inches of spare clearance, according to the build description. That means the rear end should not hang up on obstacles the front can simply steer around. It is presented as an ingenious piece of kit that took considerable thought to get right.

NV

Nerea Valdes

Nerea covers exterior protection and styling accessories, including vehicle covers, mud flaps, window deflectors, running boards, and fender flares, as an exterior fitment and weathering editor. Her assessments connect year-make-model and body configuration data with installation clearance, UV and moisture exposure, surface contact points, fastener corrosion, and documented load limits. She helps aftermarket category buyers, accessory distributors, fleet procurement teams, and installation shops verify fitment evidence, weathering test methods, packaging protection, and return-risk drivers before listing or specifying an exterior part.