Researchers in China have investigated why screen printing can degrade copper-plated silicon heterojunction (HJT) solar cells and have proposed a screen-design change to reduce the damage. The work focuses on the photoresist-printing step used in copper metallization, where mechanical contact and thermal treatment can affect the cell’s sensitive passivating contacts.
A different contact problem
Screen printing is widely used for solar cell metallization, but the process can lower device performance. The issue is particularly relevant to copper-plated HJT cells, which are seen as a route to reducing metallization costs and dependence on silver. Mechanical pressure and thermal treatments during printing can damage passivating contact structures, increasing recombination losses and reducing conversion efficiency.
Corresponding author Lang Zhou explained that photoresist printing in HJT cells differs fundamentally from conventional silver-paste printing. In silver printing, screen openings cover only 2–5% of the total area, while an emulsion layer covers the rest and prevents direct contact between the mesh and the wafer. Full-area photoresist coating typically uses a screen without emulsion coverage to ensure uniform resist deposition across the wafer. As a result, the mesh comes into direct and extensive contact with the wafer during each printing cycle.
Wear and electrical loss
Previous investigations cited by the researchers found that conversion efficiency declined from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial solar cell production. The losses were mainly attributed to reductions in open-circuit voltage and fill factor, while short-circuit current density and electrical resistance remained largely unchanged. Minority carrier lifetime degradation increased from 0.61% with a new screen to 11.0% after 15,000 printing cycles.
Using three-dimensional confocal microscopy, the scientists identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the underlying passivation layers. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements confirmed increased recombination losses, suggesting damage to the amorphous silicon/crystalline silicon interface.
An emulsion buffer layer
To address the problem, the researchers developed an emulsion buffer layer intended to prevent direct contact between the screen mesh and the wafer surface. They evaluated six patterns with emulsion coverage ratios from 2.9% to 16.6%. The results showed a trade-off between mechanical protection and photoresist coating uniformity: higher emulsion coverage reduced damage but impaired ink distribution.
An emulsion coverage ratio of 4.7% provided the best balance, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity. The researchers attributed the improvement to the emulsion layer preventing direct mesh-wafer contact and thereby reducing cumulative mechanical damage to the sensitive passivation layers.
Zhou said the findings show that a relatively simple modification to screen design can substantially mitigate printing-induced degradation and offer a practical way to improve the manufacturing reliability of copper-plated HJT solar cells. The results were presented in “Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells,” published in Solar Energy.
Copper metallization context
The development comes amid growing interest in copper as an alternative to silver contacts in HJT cells. In April 2026, researchers at China’s Nankai University developed a silver-free HJT solar cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating, addressing adhesion, contact resistance and stability challenges at the ITO interface. Separately, scientists at Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT cell. The silver-free device showed a relatively small efficiency penalty compared with its silver-metallized counterpart, while cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95% efficiency. The findings underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance are still needed.
