SinceVision has introduced the SGI-N030W, a wide-spot laser displacement sensor intended for non-contact dimensional measurement on rough, textured and irregular surfaces. The company says the new model extends its SGI Series and targets lithium-ion battery production, semiconductor processing and precision mechanical engineering, where micrometre-level readings must remain stable across changing surface finishes.
The design addresses a common limitation of point-spot laser sensors. Because those systems concentrate reflected energy on a small area, scratches, grain boundaries, brushed textures and matte coatings can create signal variations that look like dimensional changes. SinceVision says its wider optical spot collects reflected light from a larger patch of material and averages local microscopic peaks and valleys before converting the signal. The aim is to reduce sensitivity to surface roughness and scattering when measuring drawn metals, sandblasted surfaces and coated battery foils.
Measurement specifications
The sensor has a 30 mm reference distance and a ±5 mm measurement range. SinceVision specifies repeatability of 0.05 µm on a diffuse white target under static conditions and linearity of ±0.02% of full scale. A 50 kHz sampling rate, equivalent to a 20 µs update interval, is intended to support high-speed monitoring of dynamic processes. Interfaces include RS485, 100Base-TX Ethernet and switchable analogue output in either 4–20 mA or 0–10 V form. Master-slave synchronisation also allows two heads to work in opposition, measuring a component or moving material from both sides.
Battery electrode thickness
For lithium-ion electrode production, SinceVision proposes an in-line arrangement with one sensor above and one below the moving web. The heads are mounted on a calibrated, low-thermal-expansion marble gantry and measure the clearance to the material; a controller combines those readings with the fixed mounting datum to calculate absolute electrode thickness in real time. The company reports that production trials delivered repeatable measurement within ±0.3 µm at a web speed of 300 mm/s. The 50 kHz sampling rate is said to provide fine longitudinal resolution, allowing local coating agglomerations, edge thinning and exposed substrate to be detected before the electrode reaches cell winding.
SinceVision argues that conventional offline checks with contact micrometers or drop indicators can depend on operator technique and may deform wet or uncured electrode material. Periodic spot checks also cannot provide continuous coverage of an entire production reel, the company says.
Semiconductor and motion applications
In semiconductor manufacturing, the non-contact sensor is intended for wafer position verification, edge detection, height measurement and checks on wafer seating and chuck alignment in atmospheric transfer modules and vacuum load-lock systems. In precision assembly, it can monitor voice coil motors, linear actuators and micro-steppers. At 50 kHz, the sensor is designed to capture transient displacement, mechanical oscillation, settling behaviour and end-stop overshoot across the full range. Position data can be sent to machine controls over Ethernet for real-time monitoring and process control.
Surface-related errors
Jack Li, global sales and marketing director at SinceVision, says false defect warnings caused by surface texture remain a recurring problem in battery manufacturing and precision assembly. He explains that point-beam laser sensors can interpret microscopic scratches and rough coatings as actual thickness changes, slowing lines and prompting extra manual inspection. The SGI-N030W’s expanded spot is designed to average out those surface-related variations, while opposing sensor heads are synchronised for high-speed thickness verification, according to the company.
